Velodyne SC-IWBB Manuel d'utilisateur télécharger pdf (Page 44)

www.velodyne.com

38 -SC-IW Installation Manual

RETRO-FIT INSTALLATION WITH STANDARD GRILLE

Step 1 - Decide on Subwoofer Orientation and Grille Location

The rst decision for a retrot installation is which way the subwoofer will face (up or down), and therefore where

the designer grille will be located on the wall (near the oor or ceiling). Once the location is decided, locate

the 2x4 studs, spaced 16 inches on center. After the general area of the studs is located, determine the exact

location of the studs as detailed in the picture below. There are many methods to do this. Shown is the use of

a “drywall saw” used horizontally to nd the edge of each stud.

Figure 38: Subwoofer Orientation and Grille Location

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 63 64

Pas de commentaire

Velodyne SC-IWBB Manuel d'utilisateur Page 44