Velodyne SC-IWBB Manuel d'utilisateur télécharger pdf (Page 13)

www.velodyne.com

SC-IW Installation Manual - 7

Step 5 - Finish Wall

The wall can now be nished in a traditional fashion utilizing the appropriate drywall thickness, standard

texturing and nishing methods. Be sure to advise the “nishing” contractors that they are to drywall up to the

edge of the mudring, as the mudring is the place holder for the installation of the driver module and standard

grille.

Figure 4: Finish Wall

Note: Steps 6 through 14 presume that you have obtained and are ready to install the SC-IWDVR (In-Wall Driver

Module).

Step 6 - Verify Drywall was Properly Installed

Once the wall is nished, the installer must revisit the installation site and verify that the contractors have

properly used the mudring as their guide leaving an opening that is approximately 16 1/2” x 13 1/4”.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Pas de commentaire

Velodyne SC-IWBB Manuel d'utilisateur Page 13