Velodyne SC-IWBB Manuel d'utilisateur télécharger pdf (Page 12)

www.velodyne.com

6 -SC-IW Installation Manual

Step 3 - Route Wire

Route the wire from the location where the electronics gear is located to where the SC-IW will be. There is

“extra space” between the studs and the back box in the event that the wire has to pass along the side of the

back box to the driver module.

Figure 3: Route Wire

Step 4 - Cover Rubber Couplings

If the installation is not going to be nished right away, Velodyne recommends “taping” or otherwise “covering”

the two connecting tubes to prevent paint, drywall and/or foreign objects from entering the back box.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Pas de commentaire

Velodyne SC-IWBB Manuel d'utilisateur Page 12