Velodyne MicroVee Manuel d'utilisateur télécharger pdf (Page 9)

www.velodyne.com

MicroVee User’s Manual - 3

INSTALLATION

Your new Velodyne subwoofer provides for a number of installation options. Read all the installation information

below in order to determine which installation option is best suited for your system. Remember to perform all

installation procedures with system power turned off to prevent possible damage.

Figure 1. MicroVee Back Panel

Important!!! Insure that the subwoofer is only connected to the rated source voltage. Do not connnect

the 120-volt version to 230-volts or vice-versa. This will result in damage to the subwoofer and possible

injury to the user.

Inputs

Your new subwoofer is equipped with speaker-level, line-level, and MINI-JACK inputs. Use the LINE LEVEL

jacks when connecting your subwoofer to a pre-amp, signal processor, line-level crossover or receiver with

pre-amp level outputs. The SPEAKER LEVEL jacks connect directly to the speaker outputs of any amplier,

integrated amplier or receiver. Your amplier section will notice no additional loading eects when you use

these inputs due to their very high impedance. Use the MINI-JACK inputs when connecting to a docking station

or personal audio system.

Important!!! Do not use any of the LINE LEVEL, SPEAKER LEVEL, and MINI-JACK connections

simultaneously!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Velodyne MicroVee Manuel d'utilisateur Page 9